Peavey GPS 2600 power amplifier

Rated Power (2 x 2 Ohms) - 1,300 Watts @ 1 kHz both channels driven at <0.15% T.H.D.Rated Power (2 x 4 Ohms) - 950 Watts @ 1 kHz both channels driven at <0.1% T.H.D.Rated Power (2 x 8 Ohms) - 650 Watts @ 1 kHz both channels driven at <0.1% T.H.D.Minimum Load Impedance - 2 OhmsMaximum RMS Voltage Swing - 93 VoltsFrequency Response - 10 Hz - 100 kHz; +0, -.3 dB at 1 WattPower Bandwidth - 10 Hz - 40 kHz; +0, -3 dB at rated powerT.H.D. (2 x 2 Ohms) - <0.15% @ 1050 Watts from 20 Hz to 20 kHz with both channels drivenT.H.D. (2 x 4 Ohms) - <0.1% @ 900 Watts from 20 Hz to 20 kHz with both channels drivenT.H.D. (2 x 8 Ohms) - <0.1% @ 600 Watts from 20 Hz to 20 kHz with both channels drivenInput CMRR - > - 65d B @ 1 kHzVoltage Gain - x 40 (32 dB)Crosstalk - > -75 dB @ 1 kHz at rated power @ 8 OhmsHum and Noise - > -110 dB, “A” weighted referenced to rated power @ 8 OhmsPower Consumption - > 1200 WattsSlew Rate - > 40V/usDamping Factor (8 Ohms) - > 700:1 @ 20 Hz to 1 kHzSMPTE IMD - <0.1% 60 Hz and 7 kHz, 900W @ 4 OhmsInput Sensitivity (x 40) - 1.54 Volts for 4 Ohm rated power, 1.27 Volts for 2 Ohm rated powerInput Impedance - 20 k Ohms, balancedCurrent Draw @ 1/8 power@ 2 Ohms - 10 A@ 120 VoltsCooling - Two 80 mm DC fans, off until heatsinks reach 450C, then temperature dependantvariable speedControls - Two front panel attenuatorsIndicator LEDs - Two Clip, two Signal, two ActiveProtection - Thermal, DC, turn-on bursts, subsonic, incorrect loadsConnectors - XLR input, 6.3 mm phone type output patch, Speakon and Binding Post speakeroutput, IEC mains inputConstruction - 16 ga. steel reinforced with 12 ga.rack earsDimensions - 133 mm x 483 mm x 432 mm, 400 mm behind rear mounting ears(5.23" x 19" x 17", 1 Good condition working perfect read more